No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - QoS

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Interface-based Traffic Shaping

Configuring Interface-based Traffic Shaping

Context

To limit the rate of outgoing traffic on an interface, configure interface-based traffic shaping. When the packet rate exceeds the traffic shaping rate, excess packets enter the buffer queue. When there are sufficient tokens in the token bucket, the device forwards the buffered packets at an even rate. When the buffer queue is full, the device discards the buffered packets.

Procedure

  1. Run system-view

    The system view is displayed.

  2. (Optional) Run qos overhead layer { link | physics }

    A mode for calculating the packet length during traffic policing or traffic shaping is configured.

    By default, physical-layer and link-layer compensation information is included in packet lengths during traffic policing or traffic shaping.

  3. Run interface interface-type interface-number [ .subinterface-number ]

    The interface or sub-interface view is displayed.

  4. Run qos gts cir cir-value [ cbs cbs-value ]

    Traffic shaping is configured.

    By default, traffic shaping is not performed on an interface.

    NOTE:
    • Layer 2 interfaces on AR100, AR110, AR120-S, AR150-S, AR160-S, AR200-S, and AR1200-S series do not support the qos gts command.
    • The 9ES2, 4GE-2S, 4ES2G-S and 4ES2GP-S cards do not support the qos gts command.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174115

Views: 40203

Downloads: 28

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next