No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - QoS

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring Traffic Shaping on an Interface

(Optional) Configuring Traffic Shaping on an Interface

Pre-configuration Tasks

After GTS is configured on an interface, the device limits the rate of outgoing data on the interface. Traffic shaping may increase the delay.

Before configuring interface-based traffic shaping, complete the following task:
  • Configure traffic policy nesting.

Procedure

  1. Set the traffic shaping rate based on site requirements. For details, see Configuring Interface-based Traffic Shaping.
Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174115

Views: 39489

Downloads: 28

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next