No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

CLI-based Configuration Guide - QoS

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying a Traffic Policy

Applying a Traffic Policy

Pre-configuration Tasks

Before applying a traffic policy, complete the following tasks:

Configuring a Traffic Policy

Procedure

  • Apply the traffic policy to an interface.

    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number [.subinterface-number ]

      The interface view is displayed.

    3. Run traffic-policy policy-name { inbound | outbound }

      The traffic policy is applied to the inbound or outbound direction on the interface.

      By default, no traffic policy is applied to an interface.

  • Apply the traffic policy to an interzone.
    NOTE:

    Only the AR100-S&AR110-S&AR120-S&AR150-S&AR200-S series routers support this configuration.

    1. Run system-view

      The system view is displayed.

    2. Run firewall interzone zone-name1 zone-name2

      An interzone is created and the interzone view is displayed.

      By default, no interzone is created.

      You must specify two existing zones for the interzone.

    3. Run traffic-policy policy-name

      The traffic policy is bound to the interzone.

      By default, no traffic policy is bound to an interzone.

  • Apply the traffic policy to a BD.
    NOTE:

    Only the AR100-S&AR110-S&AR120-S&AR150-S&AR200-S&AR1200-S series routers support this configuration.

    1. Run system-view

      The system view is displayed.

    2. Run bridge-domain bd-id

      A BD is created and the BD view is displayed.

      By default, no BD is created.

    3. Run traffic-policy policy-name { inbound | outbound }

      The traffic policy is applied to the BD.

      By default, no traffic policy is applied to a BD.

Translation
Download
Updated: 2019-05-17

Document ID: EDOC1000174115

Views: 40209

Downloads: 28

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next