Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring CFM Parameters
By adjusting parameters of Ethernet CFM, you can better implement end-to-end Ethernet CFM on a device.
- Setting the RMEP Activation Time
The RMEP activation time is the time reserved for configuring the RMEP. The local device starts to receive CCMs at the configured activation time. - Setting the Clear Alarm Anti-jitter Time
To suppress alarm flapping, you can set the clear alarm anti-jitter time. - Setting the Alarm Anti-jitter Time
To suppress alarm flapping, you can set the alarm anti-jitter time. - Disabling a MEP from Reporting RDI Alarms
When an NMS manages many MEPs on a network, it may receive a large number of RDI alarms. To reduce such alarms, you can disable the MEPs from reporting alarms to the NMS. This reduces the load of the NMS and local device. - Configuring Association Triggered by RDI Alarms
When the device configured with association between CFM and another feature receives an RDI alarm, enable or disable association triggered by RDI alarms. - Setting the Priority of 802.1ag Packets in an MA
The 802.1ag packets with different 802.1p priorities are processed with different transmission quality. You can perform the following operations to change the priority of 802.1ag packets.
