Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for VRRP
Involved Network Elements
None
Licensing Requirements
VRRP configuration is a basic feature of a router and is not under license control.
Feature Limitations
When configuring VRRP on the router, pay attention to the following points:
- VRRP groups must use different virtual IP addresses. The virtual IP address of a VRRP group must be on the same network segment as the IP address of the interface where the VRRP group is configured.
- The devices in a VRRP group must be configured with the same VRID.
- Different interfaces can be bound to the same VRRP group.
- If both VRRP and static ARP are configured on a Dot1q termination sub-interface, QinQ termination sub-interface, or VLANIF interface on a device, an IP address mapped to a static ARP entry cannot be used as a virtual IP address. If a VRRP virtual IP address is an IP address mapped to a static ARP entry on the device, the device generates incorrect host routes, affecting traffic forwarding.
- If devices in a VRRP group use different VRRP versions, VRRP Advertisement packets may fail to be forwarded.