No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Reliability

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an RMEP

Configuring an RMEP


In the same MA, the MEPs of other devices are RMEPs of the local device. By configuring an RMEP, you can perform connectivity fault detection between the MEP and RMEP in one MA. To detect the connectivity between a device and an RMEP, you need to create the RMEP first.


  1. Run system-view

    The system view is displayed.

  2. Run cfm md md-name

    The MD view is displayed.

  3. Run ma ma-name

    The MA view is displayed.

  4. Run remote-mep mep-id mep-id [ mac mac-address ]

    An RMEP is created.

Follow-up Procedure

  • To create multiple RMEPs in an MA, repeat step 4.

  • To create RMEPs in multiple MAs, repeat step 3 to step 4.

  • To create multiple RMEPs in multiple MDs, repeat step 2 and step 4.

Updated: 2019-05-17

Document ID: EDOC1000174116

Views: 51326

Downloads: 19

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next