No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


CLI-based Configuration Guide - Reliability

AR100-S, AR110-S, AR120-S, AR150-S, AR160-S, AR200-S, AR1200-S, AR2200-S, and AR3200-S V200R009

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Understanding Interface Monitoring Groups

Understanding Interface Monitoring Groups

All monitored network-side interfaces can be added to a group, called an interface monitoring group. Each interface monitoring group is identified by a unique name. The monitored network-side interfaces are called binding interfaces. The access-side interfaces associated with an interface monitoring group are called track interfaces. As shown in Figure 3-1, the interface monitoring group has 10 binding interfaces. A down-weight can be set for each binding interface. Interfaces a, b, c, and d are track interfaces. A trigger-down-weight can be set for each track interface.

An interface monitoring group monitors the status of the binding interfaces. If the number of binding interfaces that go Down reaches a certain value, the status of corresponding track interfaces becomes Down. When the number of binding interfaces in the Down state is smaller than a certain value, the corresponding track interface goes Up again.

Figure 3-1  Interface monitoring group

As shown in Figure 3-1, the down-weight of each binding interface is set to 10, and the trigger-down-weights of track interfaces a, b, c, and d are 80, 50, 30, and 20 respectively. If two binding interfaces go Down, track interface d is triggered to go Down. If eight binding interfaces go Down, track interface d is triggered to go Down. If the number of binding interfaces in the Down state in the interface monitoring group is smaller than 8, the status of interface a will become Up again.

Currently, an interface monitoring group can monitor the physical status and BFD status of interfaces.

Updated: 2019-05-17

Document ID: EDOC1000174116

Views: 54267

Downloads: 19

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next