Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Automatic Per Packet Power Adjustment
Context
You can configure automatic per packet power adjustment on WLANs to reduce AP power consumption and interference to surrounding devices. This configuration applies to WLANs with good signal coverage.
Pre-configuration Tasks
Before configuring automatic per packet power adjustment, perform the task of Basic WLAN Service Configuration.
Procedure
- Run system-view
The system view is displayed.
- Run wlan ac
The WLAN view is displayed.
- Run radio-2g-profile name profile-name or radio-5g-profile name profile-name
The 2G or 5G radio profile view is displayed.
- Run power auto-adjust enable
Automatic per packet power adjustment is enabled for APs.
By default, automatic per packet power adjustment is disabled for an AP.
- Run quit
Return to the WLAN view.
- Bind the radio profile to an AP group or a specific AP. For the detailed procedure, see Binding a Radio Profile.
- Run quit
Return to the WLAN view.
- Run commit { all | ap-name ap-name | ap-id { ap-id1 [ to ap-id2 ] } &<1-10> }
Configurations are delivered to APs.
Verifying the Configuration
- Run the display radio-2g-profile name profile-name command to check the automatic per packet power adjustment configuration of an AP in a 2G radio profile.
- Run the display radio-5g-profile name profile-name command to check the automatic per packet power adjustment configuration of an AP in a 5G radio profile.
