No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage V100R006C10 File Storage Service Software Installation Guide 06

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Switch Through a CONSOLE Port

Logging In to a Switch Through a CONSOLE Port

Prerequisites

Prerequisites for logging in to the switch through the CONSOLE port.
  • A console cable is ready.

  • HyperTerminal software, such as PuTTY, has been installed on the PC.

    You can use the built-in HyperTerminal software (such as the HyperTerminal of Windows 2000) on the PC. If no built-in HyperTerminal software is available, use the third-party HyperTerminal software. For details, see the software user guide or online help.

Procedure

  • Logging in to the switch through the CONSOLE port.
    1. Insert the DB9 connector of the console cable to the 9-pin serial port on the PC, and insert the RJ45 connector to the CONSOLE port of the switch.

      The location of the CONSOLE port varies depending on the specific switch model. Figure 8-18 shows an example.

      Figure 8-18  Connecting to the switch through the CONSOLE port

    2. Run the HyperTerminal software on the PC, establish a connection, and set the connection port and communication parameters. PuTTY is used as an example, as shown in Figure 8-19.

      A PC may have multiple connection interfaces; therefore, the interface connected through the console cable is selected.

      Set Speed(baud) to 9600, Data bits to 8, Stop bits to 1, Parity to None, and Flow control to None.

      Figure 8-19  Terminal login page

    3. Press Enter until the following information is displayed. Enter the password and confirm password. (The following information is only for reference.)

      An initial password is required for the first login via the console. 
      Continue to set it? [Y/N]: y   
      Set a password and keep it safe! Otherwise you will not be able to log in via the console.                                           
                                                           
      Please configure the login password (8-16)
      Enter Password: 
      Confirm Password: 

Translation
Download
Updated: 2019-03-28

Document ID: EDOC1000175257

Views: 8463

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next