No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionStorage V100R006C10 File Storage Service Software Installation Guide 06

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installation Overview

Installation Overview

This chapter describes how to install FusionStorage storage cluster software in common scenarios.

When installing software, you need to ensure network communication of the installation environment. Then use the pre-installed Operation & Maintenance Tool to batch deploy the storage cluster software on all nodes over the back-end storage network. Figure 1-1 shows the procedure of software installation using direct-connection storage nodes.

Figure 1-1  Software installation diagram

The installation requirements are as follows:

  • Before software installation, you do not need to configure a maintenance IP address for each storage node (such as the IP address for the Mgmt port of a node). Their management IP addresses are automatically configured in a batch during software installation.
  • Before shipping, storage nodes already have production images inside, including the Euler Linux operating system and other software such as Operation & Maintenance Tool.
  • FusionStorage does not support the hybrid deployment of V3 nodes with V5 nodes.
  • FusionStorage supports both IPv4 and IPv6. Details are as follows:
    • The front-end service network supports both IPv4 and IPv6.
    • The back-end storage network supports only IPv4.
    • The management network supports both IPv4 and IPv6.
  • FusionStorage does not support local link IPv6 address starting with FE80 or multicase IPv6 address starting with FF00.
Translation
Download
Updated: 2019-03-28

Document ID: EDOC1000175257

Views: 8088

Downloads: 3

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next