No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Configuration

Default Configuration

This section describes default ARP configurations.

Table 7-46 describes the default configuration of ARP.

Table 7-46  Default ARP configuration


Default Configuration

Aging time of dynamic ARP entries

1200 seconds

Maximum number of probes for aging dynamic ARP entries

3 times

Aging detection mode of dynamic ARP entries

An interface sends ARP aging probe packets in broadcast mode.

Layer 2 topology detection

Layer 2 topology detection is disabled.

ARP proxy

ARP proxy is disabled.

Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 114090

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next