No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Radio Working Mode

Configuring the Radio Working Mode


Before configuring attack detection and dynamic blacklist, you need to configure the radio working mode to determine whether a radio only transmits common WLAN services or both transmits common WLAN services and performs the monitoring function.

An AP can work in two modes:
  • normal: indicates the normal mode.
    • If the air scan function is disabled on a radio, including WIDS, spectrum analysis, and terminal location, the radio is used to transmit common WLAN services.
    • If the air scan function is enabled on a radio, the radio transmits common WLAN services and also implements detection. Transmission of common WLAN services may be affected.
  • monitor: indicates the monitor mode.

    In this mode, the radio can only transmit WLAN services scanned by the air interface but cannot transmit common WLAN services.When an AP is configured to work in monitor mode, the dynamic blacklist function does not take effect.


  1. Run:


    The system view is displayed.

  2. Run:

    interface wlan-radio wlan-radio-number

    The radio interface view is displayed.

  3. Run:

    work-mode { normal | monitor }

    The working mode of an AP radio is specified.

    By default, an AP radio works in normal mode.

Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 114544

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next