No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Common Configuration Errors

Common Configuration Errors

This section describes common configuration errors.

Traffic Is Unevenly Load Balanced Between Eth-Trunk Member Interfaces Due to the Incorrect Load Balancing Mode

Fault Description

Traffic is unevenly load balanced between Eth-Trunk member interfaces due to the incorrect load balancing mode.

  1. Run the display eth-trunk command to check whether the load balancing mode of the Eth-Trunk meets networking requirements. For example, source or destination IP address-based load balancing is not recommended in Layer 2 networking.

  2. Run the load-balance command to set the proper load balancing mode.

Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 118616

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next