No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Rogue Device Detection

Configuring Rogue Device Detection

Context

Rogue devices on WLANs create security risks. To identify these devices, the administrator can enable the device detection function so that the AP can identify rogue devices.

The AP periodically detects wireless devices, including the added and changed devices in detection intervals. After several detection intervals, rogue device information may be different from that included in all the wireless device information saved on the AP. The AP periodically reports all the detected device information. If information about a rogue device is not displayed in the wireless device information, the rogue device is removed. Then the AP deletes information about the rogue device and adds it to historical records of rogue devices.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run the interface wlan-radio wlan-radio-number command to enter the radio interface view.
  3. Run:

    wids device detect enable

    Device detection is enabled.

    By default, device detection is disabled on an AP radio.

  4. (Optional) Set the intervals at which an AP detects the wireless device information.
    1. Run the quit command to return to the system view.
    2. Run the wlan command to enter the WLAN view.
    3. Run the wids command to enter the WIDS view.
    4. Run the device report-interval interval command to set the interval at which an AP detects the wireless device information.

      By default, an AP detects incremental wireless device information at an interval of 300 seconds.

Translation
Download
Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 114485

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next