No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device to Allow High Inrush Current During Power-On

Configuring the Device to Allow High Inrush Current During Power-On


High inrush current is generated when a non-standard PD is powered on. In this case, the central AP cuts off the power to the PD to protect itself. If the central AP is required to provide power for the PD, the PSE must allow high inrush current.
If high inrush current is allowed, the self-protection function of the central AP is disabled. This may damage components of the central PD.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run the ap-system-profile name profile-name command to create an AP system profile and enter the profile view.

    By default, the system provides the AP system profile default.

  4. Run the poe high-inrush enable command to configure the central AP to allow high inrush current during power-on.

    By default, interfaces do not allow high inrush current during power-on.

Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 117409

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next