No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Interference Detection

Configuring Interference Detection

Background

After the interference detection function is configured, an AP generates an alarm when one of the following interference values exceeds the alarm threshold:
  • Co-channel interference: WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.5 hwAPCoInterfDetectedTrap
  • Adjacent-channel interference: WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.7 hwNerborInterfDetectedTrap
  • STA interference: WLAN_1.3.6.1.4.1.2011.6.139.16.1.1.1.9 hwStaInterfDetectedTrap

Pre-configuration Tasks

Before configuring interference detection, perform the task of Configuring Basic WLAN Services.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    wlan

    The WLAN view is displayed.

  3. Run:

    radio-2g-profile name profile-name or radio-5g-profile name profile-name

    The 2G or 5G radio profile view is displayed.

  4. Run:

    interference detect-enable

    The interference detection function is enabled.

    By default, the interference detection function is disabled.

  5. (Optional) Configure interference detection thresholds.

    • Run the interference co-channel threshold threshold-value command to configure the alarm threshold for co-channel interference.

      By default, the alarm threshold for co-channel interference is 50%.

    • Run the interference adjacent-channel threshold threshold-value command to configure the alarm threshold for adjacent-channel interference.

      By default, the alarm threshold for adjacent-channel interference is 50%.

    • Run the interference station threshold threshold-value command to configure the alarm threshold for STA interference.

      By default, the alarm threshold for STA interference is 32.

  6. Run:

    quit

    Return to the WLAN view.

Verifying the Configuration

  • Run the display radio-2g-profile name profile-name command to check the interference detection configuration in a 2G radio profile.
  • Run the display radio-5g-profile name profile-name command to check the interference detection configuration in a 5G radio profile.
Translation
Download
Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 129942

Downloads: 312

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next