No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Online Parameters

Configuring Online Parameters


By default, no online parameters are configured on RUs in the AP view. If RU online parameters are configured in the AP view, run the display ap provision command to display the configurations.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:

    ap-id ap-id, ap-mac ap-mac, orap-name ap-name

    The AP view is displayed.

  4. Run:

    ap-name ap-new-name

    A name is configured for an RU.

    By default, no AP name is configured for an RU.


    The new RU name cannot be the same as the existing RU name.

  5. Run:

    ap-group ap-group

    The group to which an RU belongs is modified.

    By default, no AP group is configured.

  6. Configure an IP address for an RU.

    1. Run the address-mode { dhcp | static } command to configure the method used by an RU to obtain an IP address.

      By default, the mode in which an RU obtains an IP address is not configured.

    2. (Optional) Run the ip-address ip-address { mask-length | mask } [ gateway gateway ] command to configure a static IP address and gateway for an RU.

      By default, no static IPv4 address and gateway are configured for an RU.


      This step is performed only if RUs obtain IP addresses in static mode.

Checking the Configuration

  • Run the display ap provision ap-id ap-id command to display the parameter configurations in the AP view.
Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 116583

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next