No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Online Parameters

Configuring Online Parameters


By default, no online parameter is configured in the RU provisioning view, namely, RUs do not change default online parameter configurations. You can run the display provision-ap parameter-list command to view online parameter configurations in the RU provisioning view.
  • After configurations are delivered to RUs using the commit { ap-name ap-name | ap-mac ap-mac-address | ap-id ap-id | ap-group ap-group-name | all } command, the parameters displayed as - in the command output retain the default settings,

  • and the other parameters use the configured values.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:


    The RU provisioning view is displayed.

  4. Run:

    ap-name ap-new-name

    A name is configured for an RU.

    By default, no RU name is configured.


    The new RU name cannot be the same as the existing RU name.

  5. Run:

    ap-group ap-group

    The group to which an RU belongs is modified.

    By default, no AP group is configured.

  6. Configure an IP address for an RU.

    1. Run the address-mode { dhcp | static } command to configure the method used by an RU to obtain an IP address.

      By default, the mode in which an RU obtains an IP address is not configured.

    2. (Optional) Run the ip-address ip-address { mask-length | mask } [ gateway gateway ] command to configure a static IP address and gateway for an RU.

      By default, no static IPv4 address and gateway are configured for an RU.


      This step is performed only if RUs obtain IP addresses in static mode.

Checking the Configuration

  • Run the display provision-ap parameter-list command to check parameter configurations in the RU provisioning view.
Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 115676

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next