No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Hotspot2.0 Profile

Configuring a Hotspot2.0 Profile


Hotspot2.0 networks are usually provided by network service providers who can set network parameters in compliance with Hotspot2.0 standards to identify the networks. Wireless terminals can obtain network information and automatically select and access the desired networks based on the preset identity credentials. The administrator needs to configure the APs through Hotspot2.0 profiles according to the parameters provided by the network service providers so that the APs can provide Hotspot2.0 network information to the wireless terminals. After the Hotspot2.0 profiles are applied to VAP profiles, the configuration takes effect.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run:

    hotspot2-profile name profile-name

    A Hotspot2.0 profile is created and the Hotspot2.0 profile view is displayed.

    By default, no Hotspot2.0 profile is available.

  4. Run:

    network-type { emergency-service | personal-device | private | private-guest | public-chargeable | public-free | test | wildcard } [ internet-access ]

    The Hotspot2.0 network type and Internet access status are configured.

    By default, the network type is set to wildcard, and Internet access is not supported.

  5. (Optional) Run:

    hessid mac-address

    HESSID of the Hotspot2.0 network is configured.

    By default, no HESSID is configured.

  6. (Optional) Run:

    venue-type group-code venue-group type-code type-code-value

    The venue type of the Hotspot2.0 network is configured.

    By default, the values of venue group type and subtype are set to 255 and reserved. No venue type information is available.

  7. (Optional) Run:

    network-authen-type { acceptance [ redirect-url url ] | dns-redirection | http-https-redirection redirect-url url | online-enroll }

    The authentication type of the Hotspot2.0 network is configured.

    By default, no network authentication type is configured.

  8. (Optional) Run:

    ipv4-address-avail { not-available | available | port-restricted [ single-nat | double-nat ] | private { single-nat | double-nat } | unknown }

    Available IPv4 address types of the Hotspot2.0 network are configured.

    By default, no available type of IPv4 addresses is configured.

Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 118106

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next