No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling the PoE Function

Enabling the PoE Function


Before using a central AP to provide power for PDs connected to its interfaces, ensure that the PoE function is enabled on the interfaces.


  1. Run:


    The system view is displayed.

  2. Run:


    The WLAN view is displayed.

  3. Run the port-link-profile name profile-name command to create an AP wired port link profile and enter the profile view.

    By default, the system provides the AP wired port link profile default.

  4. Run the undo poe disable command to enable the PoE function on the central AP's interfaces.

    By default, the PoE function is enabled on a central AP's interface.

Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 118722

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next