No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring IGMP Snooping

Configuring IGMP Snooping

This section describes the procedures for configuring IGMP Snooping.

Configuring Basic IGMP Snooping Functions

Basic IGMP snooping functions enable a device to create and maintain a Layer 2 multicast forwarding table and implement on-demand multicast data transmission at the data link layer.

Pre-configuration Tasks

A VLAN has been created.

Enabling IGMP Snooping

Context

Other IGMP snooping functions can be configured only after IGMP snooping is enabled globally. Other IGMP snooping functions take effect in a VLAN only after IGMP snooping is enabled in the VLAN.

By default, IGMP snooping is disabled globally on the access point.

Procedure

  1. Run:

    system-view

    The system view is displayed.

  2. Run:

    igmp-snooping enable

    IGMP snooping is enabled globally.

    After IGMP snooping is enabled globally, the device can process IGMPv1, IGMPv2, and IGMPv3 packets.

  3. Run:

    vlan vlan-id

    The VLAN view is displayed.

  4. Run:

    igmp-snooping enable

    IGMP snooping is enabled in the VLAN.

  5. (Optional) Configure multicast-to-unicast conversion on the wireless side.
    1. Run:

      quit

      Return to the system view.

    2. Run:

      wlan

      The WLAN view is displayed.

    3. Run:

      traffic-profile  name profile-name

      The traffic profile view is displayed.

Checking the Configuration

Context

After the configurations are complete, run the following commands in any view to check IGMP spooning configurations and the forwarding entries.

Procedure

  • Run the display igmp-snooping configuration command to check the IGMP snooping configuration in a VLAN.
  • Run the display l2-multicast forwarding-table vlan vlan-id command to check the multicast forwarding table in a VLAN.
Translation
Download
Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 114691

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next