No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Fat AP and Cloud AP V200R008C00 CLI-based Configuration Guide

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuration Examples

Configuration Examples

Example for Configuring PoE

Networking Requirements

As shown in Figure 5-22, the APs are placed outside the office and cannot connect to the power module. Directly provide power supplies for the APs to save the device deployment cost.

Among the APs, AP1 is the most important one because it provides WLAN services for visitors. Therefore, the power supply for AP1 takes precedence over that for other APs.

Figure 5-22  Networking diagram of the PoE application
Configuration Roadmap

The APs must support the PoE function.

The configuration roadmap is as follows:

  1. Configure the automatic power management mode for the device to flexibly manage the connected PD devices.
  2. Configure the power supply priority of GigabitEthernet0/0/1 on the device to Critical to guarantee the power supply for AP1.

Procedure

  1. # Set the device power management mode to automatic.

    <Huawei> system-view
    [Huawei] poe power-management auto 

  2. Set the power supply priority of GigabitEthernet0/0/1 to Critical.

    [Huawei] interface gigabitethernet 0/0/1
    [Huawei-GigabitEthernet0/0/1] poe priority critical
    [Huawei-GigabitEthernet0/0/1] quit

  3. Verify the configuration.

    # Display the PoE power supply status of the interface on the device.

    [Huawei] display poe power-state
    PORTNAME                 POWERON/OFF  ENABLED  PRIORITY STATUS
    --------------------------------------------------------------------------------
    GigabitEthernet0/0/1     on           enable   Critical Powered
    GigabitEthernet0/0/2     on           enable   Low      Powered
    GigabitEthernet0/0/3     on           enable   Low      Powered
    GigabitEthernet0/0/4     on           enable   Low      Powered
    GigabitEthernet0/0/5     off          enable   Low      Detecting
    GigabitEthernet0/0/6     off          enable   Low      Detecting
    GigabitEthernet0/0/7     off          enable   Low      Detecting
    GigabitEthernet0/0/8     off          enable   Low      Detecting
    

Configuration Files
#
interface GigabitEthernet0/0/1
 poe priority Critical
#
return                         
Translation
Download
Updated: 2019-01-11

Document ID: EDOC1000176006

Views: 116221

Downloads: 309

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next