No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade
TP3206-65 V100R002C10 Installation Guide
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
About This Document

About This Document

Overview

This document describes the tools, steps, and cable routing paths for installing the TP3206-65 telepresence system (TP3206-65 for short).

The TP3206-65 comes with three 65-inch displays.

Intended Audience

This document is intended for:

  • Technical support engineers
  • Huawei agents

Symbol Conventions

The symbols that may be found in this document are defined as follows.

Symbol

Description

Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.

Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.

Indicates a potentially hazardous situation which, if not avoided, could result in equipment damage, data loss, performance deterioration, or unanticipated results.

NOTICE is used to address practices not related to personal injury.

Indicates protective grounding. This symbol is attached near the protective ground terminal and is used beside a terminal through which a device is connected to an external ground grid. A device ground cable is connected from the protective ground terminal to the external ground bar.

Calls attention to important information, best practices and tips.

NOTE is used to address information not related to personal injury, equipment damage, and environment deterioration.

Direction Conventions

Unless otherwise specified, the left, center, and right directions are defined when you face the displays.

Installation Conventions

Unless otherwise specified, the installation must meet the following requirements:

  • Use a hexagon rechargeable electric screwdriver to tighten the M6 x 16 hex socket screws.
  • When using a rechargeable battery-powered electric screwdriver to tighten the screws, the recommended torque is 3-5 N m.

Change History

Changes between document issues are cumulative. The latest document issue contains all the changes made in earlier issues.

Issue 05 (2019-12-20)

This issue is the third official release. The following content is updated:

Updated section 5.2 "Mounting Brackets".

Updated section 6.8 "Installing the PDUs in the Left and Right Racks".

Issue 04 (2019-08-16)

This issue is the fourth official release. The following content is updated:

Updated section 5.5 "Installing the Camera".

Issue 03 (2019-06-04)

This issue is the third official release. The following content is updated:

Updated section 5.2 "Mounting Brackets".

Issue 02 (2018-01-10)

This issue is the second official release. The following content is updated:

Updated section 6.4 "Installing the Wireless Router".

Issue 01 (2017-10-31)

This issue is the first official release.

Translation
Download
Updated: 2019-12-26

Document ID: EDOC1000177089

Views: 8837

Downloads: 32

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Share
Previous Next