No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Huawei Rack Server iBMC (V260 to V278) User Guide 11

Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Logging In to a Server Over a Network Port Using PuTTY

Logging In to a Server Over a Network Port Using PuTTY

Scenarios

Use PuTTY to remotely log in to a server over a local area network (LAN) and configure and maintain the server.

Prerequisites

Conditions

The local PC is connected to the management network port of the server through a network cable.

Data

  • IP address of the server
  • User name and password for logging in to the server

Software

PuTTY, free software available at the chiark website.

Procedure

    1. Set an IP address and a subnet mask or add route information for the PC, and ensure that the PC can properly communicate with the server.
    2. On the PC command-line interface (CLI), run the following command to check whether the server is reachable:

      Ping Server IP address

    3. Double-click PuTTY.exe.

      The PuTTY Configuration window is displayed, as shown in Figure 6-2.

      Figure 6-2 PuTTY Configuration window

    4. Set login parameters.

      • Host Name (or IP address): Enter the IP address of the server to be logged in to. For example, 191.100.34.32.
      • Port: Retain the default value 22.
      • Connection type: Retain the default value SSH.
      • Close window on exit: Retain the default value Only on clean exit.
      NOTE:

      Configure Host Name and Saved Sessions, and click Save. You can double-click the saved record in Saved Sessions to log in to the server next time.

    5. Click Open.

      The PuTTY login window is displayed.

      NOTE:

      If this is your first login to the server, the PuTTY Security Alert dialog box is displayed. Click Yes to proceed.

    6. Enter the user name and password.

      NOTE:

      If an incorrect user name or password is entered, you must set up a new PuTTY session.

      If the login is successful, the server host name is displayed on the left of the prompt.

Download
Updated: 2019-02-28

Document ID: EDOC1000177670

Views: 108878

Downloads: 566

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next