No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIP to Deny Host Routes

Configuring RIP to Deny Host Routes

Context

In certain cases, the switch receives a large number of host routes with 32 bits from the same network segment. These host routes are unnecessary for routing, and they waste network resources. You can configure the switch to reject all the host routes it receives.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rip [ process-id ]

    The RIP view is displayed.

  3. Run undo host-route

    Host routes are not added to the RIP routing table.

    By default, host routes can be added to the routing table on the switch.

    NOTE:

    The undo host-route command is invalid for RIP-2.

Translation
Download
Updated: 2019-09-23

Document ID: EDOC1000178018

Views: 130522

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next