No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Interface to Insert the Actual MTU into DD Packets

Configuring an Interface to Insert the Actual MTU into DD Packets


After virtual links are created, devices from different vendors may use different default MTUs. To ensure consistency, the default MTU is set to 0 when the interface sends DD packets.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The OSPF interface view is displayed.

  3. Run ospf mtu-enable

    The interface is configured to insert the actual MTU into DD packets and check whether the MTU in DD packets from the neighbor exceeds the MTU of the local end.

    By default, the MTU in DD packets sent by an interface is 0.

    Performing this procedure causes the re-establishment of neighbor relationships.

Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131727

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next