No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Authentication Mode

Configuring an Authentication Mode

Context

OSPFv3 supports HMAC-SHA256 authentication modes. The following procedure uses keychain authentication as an example.

If plain is selected during the authentication mode configuration, the password is saved in the configuration file in plain text. This is a security risk. It is recommended that you select cipher to save the password in cipher text.

Procedure

  • Configure OSPFv3 area authentication.
    1. Run system-view

      The system view is displayed.

    2. Run ospfv3 [ process-id ]

      The OSPFv3 process view is displayed.

    3. Run area area-id

      The OSPFv3 area view is displayed.

    4. Run authentication-mode hmac-sha256 key-id key-id { plain plain-text | [ cipher ] cipher-text }

      OSPFv3 area authentication is configured.

      NOTE:

      If you use OSPFv3 area authentication, the authentication and password configurations on all switch in the same area must be the same.

  • Configure OSPFv3 process authentication.
    1. Run system-view

      The system view is displayed.

    2. Run ospfv3 [ process-id ]

      The OSPFv3 process view is displayed.

    3. Run authentication-mode hmac-sha256 key-id key-id { plain plain-text | [ cipher ] cipher-text }

      OSPFv3 process authentication is configured.

  • Configure OSPFv3 interface authentication.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The interface view is displayed.

    3. Run ospfv3 authentication-mode hmac-sha256 key-id key-id { plain plain-text | [ cipher ] cipher-text }

      OSPFv3 interface authentication is configured.

      OSPFv3 interface authentication takes precedence over OSPFv3 area authentication.

      If you use HMAC-SHA256 authentication, the authentication and password configurations on all the interfaces on the same network segment must be the same.

Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000178018

Views: 125541

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next