No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the Default Preference Value for IPv6 Static Routes

(Optional) Setting the Default Preference Value for IPv6 Static Routes

Context

The default preference value of IPv6 static routes affects route selection. When an IPv6 static route is configured without specifying a preference value, the default preference value is used.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ipv6 route-static default-preference preference

    The default preference value of IPv6 static routes is set.

    The default preference value of static routes is initially set to 60.

    After the default preference value is reconfigured, the new default preference value is valid only for new IPv6 static routes.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 130960

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next