No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Network Management Functions for OSPF

Configuring Network Management Functions for OSPF

Pre-configuration Tasks

OSPF supports the network management function. You can bind the OSPF MIB to an OSPF process and configure the trap and log functions.

Before configuring network management functions for OSPF, complete the following tasks:

Configuration Procedure

Perform one or more configuration tasks as required (the task of Verifying the OSPF Network Management Function Configuration must be performed).

Updated: 2019-09-23

Document ID: EDOC1000178018

Views: 130501

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next