No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Applying Filters to Received Routes

Applying Filters to Received Routes

Procedure

  • Configuring RIP to filter received routes
    1. Run system-view

      The system view is displayed.

    2. Run rip [ process-id ]

      The RIP view is displayed.

    3. Depending on type of desired filtering, run one of following commands to configure RIP to filter the received routes:

      • Run filter-policy { acl-number | acl-name acl-name } import [ interface-type interface-number ]

        Learned routing information is filtered based on an ACL.

      • Run filter-policy gateway ip-prefix-name import

        Routing information advertised by neighbors is filtered based on the IP prefix list.

      • Run filter-policy ip-prefix ip-prefix-name [ gateway ip-prefix-name ] import [ interface-type interface-number ]

        Routes learned by the specified interface are filtered based on the IP prefix list and neighbors.

  • Configuring OSPF to filter received routes
    1. Run system-view

      The system view is displayed.

    2. Run ospf [ process-id ]

      The OSPF process view is displayed.

    3. Run filter-policy { acl-number | acl-name acl-name | ip-prefix ip-prefix-name | route-policy route-policy-name [ secondary ] } import

      OSPF is configured to filter received routes.

      • The acl-number parameter specifies the number of a basic ACL.
      • The acl-name acl-name parameter specifies the name of an ACL.
      • The ip-prefix ip-prefix-name parameter specifies the name of an IP prefix list.

      The filter-policy import command filters the routes calculated by OSPF but cannot filter advertised or received LSAs. Only the routes that pass the filtering criteria are added to the OSPF routing table. However, routes that do not pass the filtering criteria are not added to the OSPF routing table but can still be advertised.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131240

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next