No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring RIP-2 Packet Authentication

Configuring RIP-2 Packet Authentication


Configure RIP-2 packet authentication on a RIP network requiring high security.

RIP-2 can perform simple authentication or MD5 authentication on protocol packets. In simple authentication, the plain text authentication key is used. Therefore, simple authentication has lower security than MD5.

If plain is selected during the configuration of the RIP-2 packet authentication mode, the password is saved in the configuration file in plain text. This brings security risks. It is recommended that you select cipher to save the password in cipher text.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Configure RIP-2 packet authentication.

    • Run the rip authentication-mode simple { plain plain-text | [ cipher ] password-key } command to set RIP-2 packet authentication to simple authentication.

    • Run the following commands to set RIP-2 packet authentication to MD5 authentication.

      • rip authentication-mode md5 usual { plain plain-text | [ cipher ] password-key }
      • rip authentication-mode md5 nonstandard { plain plain-text | [ cipher ] password-key } key-id

      Simple authentication and MD5 authentication have potential risks. HMAC-SHA256 cipher text authentication is recommended.

      If MD5 authentication is used, you must set the packet format for MD5 authentication. If the usual keyword is specified, MD5 cipher text authentication packets use the universal format (private standard). If the nonstandard keyword is specified, MD5 cipher text authentication packets use the non-standard format (IETF standard).

    • Run the rip authentication-mode hmac-sha256 { plain plain-text | [ cipher ] password-key } key-id command to set RIP-2 packet authentication to HMAC-SHA256 authentication.

Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131830

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next