No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring OSPF GR

Configuring OSPF GR

Applicable Environment

To avoid traffic interruption and route flapping caused by master/slave switchovers, configure OSPF GR.

After an OSPF process is restarted through GR, the Restarter and the Helper reestablish a neighbor relationship, exchange routing information, synchronize their LSDBs, and update their routing tables and forwarding tables. These operations ensure fast OSPF convergence and network topology stability.

NOTE:

Where possible, to prevent service forwarding from being affected by faults on a main control board, configure OSPF GR when dual main control boards are deployed.

Pre-configuration Tasks

Before configuring OSPF GR, complete the following tasks:

Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000178018

Views: 125683

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next