No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an OSPFv3 Area

Configuring an OSPFv3 Area

Applicable Environment

Define OSPFv3 areas to reduce the number of LSAs in the network and enhance OSPFv3 extensibility. To further reduce the size of routing tables and number of LSAs, specify some non-backbone areas at the edge of ASs as stub areas.

Pre-configuration Tasks

Before configuring OSPFv3 area attributes, configure basic OSPFv3 functions.

Updated: 2020-01-22

Document ID: EDOC1000178018

Views: 151054

Downloads: 22

Average rating:
This Document Applies to these Products

Related Version

Related Documents

Previous Next