No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the OSPF Session Parameter Configuration

Verifying the OSPF Session Parameter Configuration


All configurations about session parameters of OSPF neighbor or adjacency relationships are complete.


  • Run the display ospf [ process-id ] peer command to check information about OSPF neighbors.
  • Run the display ospf [ process-id ] brief command to check brief information about the specified OSPF process.
  • Run the display ospf [ process-id ] retrans-queue [ interface-type interface-number ] [ neighbor-id ] [ low-level-of-retrans-times-range min-time ] [ high-level-of-retrans-times-range max-time ] command to check the OSPF retransmission list.
Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131339

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next