No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Associating IPv4 Static Routes with EFM

Associating IPv4 Static Routes with EFM

Background

EFM for static routes can be configured to provide a fault detection mechanism for static routes so that the static routes can detect the link quality changes in real time and switch services immediately. You can associate Ethernet in the First Mile (EFM) with an IPv4 static route so that the associated static route can be deleted from the IP routing table when the EFM session of a specified interface goes Down. Traffic is then switched to a route without link faults to prevent lengthy service interruptions.

Pre-configuration Tasks

Before associating IPv4 static routes with EFM, set link layer protocol parameters and assign IP addresses to interfaces to ensure that the link layer protocol status of the interfaces is Up.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ip route-static ip-address { mask | mask-length } { nexthop-address | interface-type interface-number [ nexthop-address ] } [ preference preference ] track efm-state interface-type interface-number [ description text ]

    EFM is associated with the IPv4 static route.

Verifying the Configuration

  • Run the display efm session { all | interface interface-type interface-number command to check information about EFM OAM on a specified interface.

  • Run the display current-configuration | include efm command to check associations between EFM and IPv4 static routes.

Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131620

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next