No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a RIPng Process to Import External Routes

Configuring a RIPng Process to Import External Routes


A RIPng process can import the routes learned by other processes or routing protocols to enrich its routing information.


  1. Run system-view

    The system view is displayed.

  2. Run ripng [ process-id ] [ vpn-instance vpn-instance-name ]

    The RIPng view is displayed.

  3. (Optional) Run default-cost cost

    The default cost of external routes to be imported is set.

    By default, the default cost of RIPng routes is 0.

    If no cost is set for external routes to be imported, the default cost is used.

  4. Run import-route { { ripng | ospfv3 } [ process-id ] | unr | direct | static } [ [ cost cost | inherit-cost ] | route-policy route-policy-name ] *

    External routes are imported.

  5. (Optional) Run filter-policy { acl6-number | acl6-name acl6-name | ipv6-prefix ipv6-prefix-name | route-policy route-policy-name } export [ protocol [ process-id ] ]

    The RIPng process is configured to filter imported routes.

    A RIPng process can use ACL6, route policy and IPv6 prefix lists to filter imported routes, allowing only the routes matching ACL6, route policy and IPv6 prefix lists to be advertised to RIPng neighbors. If protocol is not specified, the RIPng process filters all the routes to be advertised, including imported routes and local RIPng routes (similar to direct routes).

Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131405

Downloads: 18

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next