No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling OSPFv3 on an Interface

Enabling OSPFv3 on an Interface


After enabling OSPFv3 in the system view, enable OSPFv3 on an interface.

Because an interface has multiple instances, specify in which instance OSPFv3 is enabled. If no instance ID is specified, the value defaults to 0. The same instance must be enabled on interfaces between which the neighbor relationship is set up.

Perform the following operations on the switch that runs OSPFv3.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. Run ospfv3 process-id area area-id [ instance instance-id ]

    OSPFv3 is enabled on the interface.

    The area ID can be entered as a decimal integer or in the IPv4 address format, but it is always displayed in the IPv4 address format.

  4. (Optional) Run the ospfv3 network-type { broadcast | nbma | p2mp [ non-broadcast ] | p2p } [ instance instance-id ] command to configure a network type for the interface.


    When an interface supports multi-instances, you must specify the value of instance-id when enabling OSPFv3 on the interface. If the value of instance-id is not specified, the default value 0 is used. In this case, the configured network type of an interface may not match the actual network type of the interface. This step is mandatory in such a case.

Updated: 2019-10-18

Document ID: EDOC1000178018

Views: 131158

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next