No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Resetting OSPFv3

Resetting OSPFv3


OSPFv3 adjacency relationships are removed when you reset OSPFv3 connections. Exercise caution when running the reset ospfv3 command.

After modifying an OSPFv3 routing policy or protocol, reset the OSPFv3 connections to validate the modification.


  • To reset OSPFv3 connections and validate the new configuration, run the following commands in the user view:

    • reset ospfv3 { process-id | all } [ graceful-restart [ extend-period period ] ]

    • reset ospfv3 { process-id | all } counters [ neighbor [ interface-type interface-number ] [ router-id ] ]

Updated: 2019-09-23

Document ID: EDOC1000178018

Views: 130238

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next