No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - IP Unicast Routing

This document describes IP Unicast Routing configurations supported by the switch, including the principle and configuration procedures of IP Routing Overview, Static Route, RIP, RIPng, OSPF, Routing Policy ,and PBR, and provides configuration examples.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an Area Authentication Mode

Configuring an Area Authentication Mode

Context

In area authentication, all the switches in an area must use the same area authentication mode and password. For example, all switches in Area 0 are configured to use simple authentication and a password of abc.

If plain is selected, the password is saved in plaintext in the configuration file. To improve security, select cipher to save the password in ciphertext.

Simple, MD5 authentication, and HMAC-MD5 cipher text authentication have potential security risks. HMAC-SHA256 ciphertext authentication is recommended.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run ospf [ process-id ]

    The OSPF process view is displayed.

  3. Run area area-id

    The OSPF area view is displayed.

  4. Run any of the following commands to configure an authentication mode for the OSPF area as required:

    • Run authentication-mode simple [ plain plain-text | [ cipher ] cipher-text ]

      Simple authentication is configured for the OSPF area.

      • plain indicates that the password is stored in plaintext.
      • cipher indicates the password is stored in ciphertext. For MD5 or HMAC-MD5 authentication, the authentication mode is in ciphertext by default.
    • Run authentication-mode { md5 | hmac-md5 | hmac-sha256 } [ key-id { plain plain-text | [ cipher ] cipher-text } ]

      An authentication mode is configured for the OSPF area.

      • md5 indicates that the MD5 ciphertext authentication mode is used.

      • hmac-md5 indicates that the HMAC-MD5 ciphertext authentication mode is used.
      • hmac-sha256 indicates that the HMAC-SHA256 ciphertext authentication mode is used.
      • key-id specifies the authentication key ID of the cipher authentication.

Translation
Download
Updated: 2019-09-23

Document ID: EDOC1000178018

Views: 130067

Downloads: 17

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next