No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, and sFlow.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the NQA Client to Send Traps When a Test Fails

Configuring the NQA Client to Send Traps When a Test Fails



Path jitter test does not support the traps for test failures.


  1. Run system-view

    The system view is displayed.

  2. Run nqa test-instance admin-name test-name

    The NQA view is displayed.

  3. Run send-trap testfailure

    The NQA client is configured to send traps when the test fails.

    By default, the NQA client sends no trap when an NQA test fails.

  4. Run test-failtimes times

    The threshold on the traps sent after the NQA test fails is configured. The threshold specifies maximum number of continuous test failures for the NQA test instance.

    By default, a trap is sent for each test failure.

Updated: 2019-03-30

Document ID: EDOC1000178020

Views: 62894

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next