No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, and sFlow.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring an SNMP Test Instance

Configuring an SNMP Test Instance


Before configuring an SNMP test instance, configure an SNMP agent and ensure reachable routes between the NQA client and the SNMP agent.

You can obtain the statistics about communication between the NQA client and the SNMP agent.


Perform the following steps on the NQA client.


  1. Run system-view

    The system view is displayed.

  2. Run nqa test-instance admin-name test-name

    An NQA test instance is created, and the NQA view is displayed.

  3. Run test-type snmp

    The test type is set to SNMP.

  4. Run destination-address ipv4 ipv4-address

    The destination IP address (IP address of the SNMP agent) is configured.


    The SNMP function must be enabled on the destination host, otherwise, the NQA client cannot receive response packets.

  5. (Optional) Run community read cipher community-name

    The community name is set for SNMP test.

    When the SNMP versions on agents are SNMPv1 or SNMPv2c, the community name must be configured using the community read cipher command, and the community name must be a read-only community name on SNMP agents. When the SNMP versions on agents are SNMPv3, the community name does not need to be configured because SNMPv3 does not support community names.

  6. (Optional) Run the following commands as required to configure parameters for the SNMP test.

    • Run description string

      A description is configured for the test instance.

    • Run frequency interval

      The test period is set for the NQA test instance.

    • Run timeout time

      The timeout period of a probe is set for the NQA test instance.

    • Run source-address ipv4 ipv4-address

      The source IP address is configured.

    • Run source-port port-number

      The source port number is configured.

    • Run ttl number

      The TTL value in the NQA test packet is set.

    • Run sendpacket passroute

      The NQA test instance is configured to send packets without searching the routing table.

    • Run probe-count number

      The number of probes in a test is set.

    • Run tos value

      Type of Service (ToS) is set for the test packet.

    • Run fail-percent percent

      The failure percentage is set for the NQA test instance.

    • Run interval seconds interval

      The interval at which test packets are sent is configured.

    • Run vpn-instance vpn-instance-name

      The VPN instance name is configured.

    • Run records history number

      The maximum number of historical records is set for the NQA test instance.

    • Run records result number

      The maximum number of result records is set for the NQA test instance.

    • Run agetime hh:mm:ss

      The aging time is set for the NQA test instance.

Updated: 2019-03-30

Document ID: EDOC1000178020

Views: 63069

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next