No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, and sFlow.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a Device to Communicate with an NMS Through SNMPv2c

Configuring a Device to Communicate with an NMS Through SNMPv2c

Context

To allow a device to communicate with an NMS through SNMPv2c, configure SNMPv2c on the device. The SNMP parameters must be configured on both the managed device (agent) and NMS. This section describes only the SNMP configurations on the agent side. For details about SNMP configurations on an NMS, see the NMS operation guide.

Pre-configuration Tasks

Before configuring a device to communicate with an NMS through SNMPv2c, configure a routing protocol to ensure that at least one route exists between switch and NMS.

Configuration Procedure

When you configure a device to communicate with the NMS using SNMPv2c, only basic functions from Configuring Basic SNMPv2c Functions are mandatory. The other steps are optional and can be performed in any sequence.

After the SNMP basic functions are configured, the switch and NMS can communicate with each other.
  • The NMS using the specified community name can access the ViewDefault view, in which the internet MIB (OID: 1.3.6.1) can be operated.

  • The managed device sends traps generated by the modules that are enabled by default to the NMS.

The following are optional SNMPv2c configurations to implement refined management:
Translation
Download
Updated: 2019-10-18

Document ID: EDOC1000178020

Views: 74760

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next