No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, and sFlow.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
ICMP Test

ICMP Test

The NQA Internet Control Message Protocol (ICMP) test detects whether there are reachable routes from the source to the destination. It has a similar function to the ping command, but provides more output information, including:

  • Average delay
  • Packet loss ratio
  • Time the last packet was correctly received

The system saves the results of the latest five tests by default.

The ICMP test process is as follows:
  1. The source (SwitchA) constructs an ICMP Echo Request packet and sends it to the destination (SwitchB).

  2. The destination receives the ICMP Echo Request packet and responds with an ICMP Echo Reply packet.

  3. The source receives the ICMP Echo Reply packet and calculates the time between when it sent the ICMP Echo Request packet and when it received the ICMP Echo Reply packet.

Figure 4-4  Network for ICMP test

The ICMP test results and historical records are collected in test instances. You can run commands to view the test results and historical records.

NOTE:

An ICMP test is usually conducted to check the connectivity. However, it cannot accurately test the link delay. Therefore, to test link delay or other link performance, you are advised to conduct an ICMP jitter or UDP jitter test.

Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000178020

Views: 56490

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next