No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON, LLDP, NQA, Service Diagnosis, Mirroring, Packet Capture, and sFlow.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Why Does a Device Fail to Report Interface Up/Down Traps to the NMS and How Can I Disable the Up/Down Traps of a Specified Interface?

Why Does a Device Fail to Report Interface Up/Down Traps to the NMS and How Can I Disable the Up/Down Traps of a Specified Interface?

By default, the interface status trap function is globally disabled. Therefore, when an interface changes status, no trap is generated. Run the snmp-agent trap enable feature-name ifnet trap-name { linkdown | linkup } command to enable the interface status trap function globally. When interface status frequently changes, a large number of traps are sent to the NMS, increasing the load on the NMS. In this situation, you can disable the interface status trap function. The procedure is as follows:
  1. Run the interface interface-type interface-number command to enter the interface view.
  2. Run the undo enable snmp trap updown command to disable the interface status trap function.

The following example shows how to disable the device from sending traps to the NMS when any interface changes its status to Up.

<HUAWEI> system-view
[HUAWEI] snmp-agent trap enable feature-name ifnet trap-name linkup

The following example shows how to disable the device from sending traps to the NMS when GE0/0/1 changes its status.

<HUAWEI> system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] undo enable snmp trap updown
Translation
Download
Updated: 2019-03-30

Document ID: EDOC1000178020

Views: 57278

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next