No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Web-based Configuration Guide

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).


This chapter describes how to configure PoE. PDs, such as wireless telephones and APs, are provided with power when the devices are configured with PoE.



Only the product models with PWR in the product names support PoE.


  1. Choose Configuration > Advanced Services > PoE.
  2. Perform global settings and click Apply, as shown in Figure 5-80.

    Figure 5-80  Global Settings

    Table 5-42 describes the parameters in Global Settings.

    Table 5-42  Parameters in Global Settings



    Power supply management mode

    Configures the switch's power supply management mode:
    • Auto
    • Manual

    Max output power (mW)

    Sets the maximum output power of the switch, in mW.

    Reserved PoE power (%)

    Sets the percentage of the reserved PoE power against the total PoE power.

  3. Select a port to be configured. Perform the following operations as required in the port area:

    • Click a port icon. To deselect the port, click the port icon again.
    • Drag the cursor to select consecutive ports in a batch.
    • Click multiple port icons to select these ports, and click a port icon again to deselect the port.
    • Select a slot where a panel is located. All ports on the panel are selected.

  4. Configure interfaces.

    Figure 5-81  Interface Setting

    Table 5-43 describes the parameters in Interface Setting.

    Table 5-43  Parameters in Interface Setting



    Interface name

    Indicates the currently configured interface name. This parameter cannot be modified.

    Enable PoE on interface

    Indicates whether to enable the PoE function:
    • ON: Enable the PoE function.
    • OFF: Disable the PoE function.

    Max output power (mW)

    Sets the maximum output power of the interface, in mW.

    PoE priority

    Configures the power supply priority for an interface:
    • Low: the lowest priority
    • High: the second highest priority
    • Critical: the highest priority

    Manual power supply

    Configures the manual power supply mode:
    • Power on: Interfaces will be manually powered on.
    • Power off: Interfaces will be manually powered off.

    PD compatibility check

    Indicates whether to enable non-standard PD compatibility check on an interface:
    • ON: Enable non-standard PD compatibility check.
    • OFF: Disable non-standard PD compatibility check.

  5. Click Apply to make the configuration take effect.
Updated: 2019-09-23

Document ID: EDOC1000178031

Views: 33790

Downloads: 9

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next