No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R011C10 Web-based Configuration Guide

This document describes the configuration and maintenance of device through the web network management system. The web network management system provides the functions of viewing device information and managing the entire system, interfaces, services, ACL, QoS, routes, security, and tools.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).



For device support for stack, see Stacking Support and Version Requirements in "Stack Configuration" in the S600-E V200R011C10 Configuration Guide - Device Management.
This page is displayed when the stacking function is enabled using the stack enable command in the diagnostic view.


  1. Choose Configuration > Advanced Services > Stack in the navigation tree to open the Stack page, as shown in Figure 5-85.

    Figure 5-85  Stack configuration page

  2. Click the data line below Configure Stack Members to configure Master switch, Standby switch, or Slave switch, as shown in Figure 5-86. Set parameters and click .

    Standby switch or Slave switch is displayed only when the switch joins a stack.
    Figure 5-86  Stack member configuration page

  3. Click Master switch, Standby switch, or Slave switch below Configure Stack Members to open the Configure Stack Ports (Slot ID) page, select the appropriate data line, and Manage appears, as shown in Figure 5-87.

    Figure 5-87  Stack port configuration page

  4. Click Manage. In the displayed page, select stack member ports and click .

    To withdraw a stack member port, click Manage and deselect this port on the displayed page, and click .

  5. Click Apply. In the dialog box that is displayed, click OK. Check stack information below Display Information.
Updated: 2019-10-18

Document ID: EDOC1000178031

Views: 34275

Downloads: 10

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next