No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of iPCA Configuration Tasks

Summary of iPCA Configuration Tasks

As shown Figure 5-15, employees in the enterprise branch and headquarters are participating in a video conference.

Figure 5-15  iPCA packet loss measurement networking

Table 5-2 lists the iPCA scenarios and corresponding configurations.

Table 5-2  iPCA configuration tasks

Scenario

Description

Task

Employees participating in the conference encounter erratic display and voice delay. The network administrator wants to monitor packet loss on the network.

Configure end-to-end packet loss measurement on interface C1 of core switch S2 and interface C2 of core switch S5, to monitor network quality.

Configuring iPCA to Implement Network-Level Packet Loss Measurement

The network administrator considers that packet loss occurs on the WAN and cause network quality to degrade. Therefore, the administrator wants to diagnose or monitor packet loss.

Configure regional network packet loss measurement between interface D1 of egress gateway S3 and interface D2 of egress gateway S4 to locate faults.

Configuring iPCA to Implement Network-Level Packet Loss Measurement

The network administrator discovers packet loss on the headquarters and enterprise branch networks, and wants to monitor or diagnose packet loss on the entire network for fault location.

Configure hop-by-hop packet loss measurement on interface A1 of switch S1 and interface A2 of switch S6 to show quality on each node through the MCP.

Configuring iPCA to Implement Network-Level Hop-by-Hop Packet Loss Measurement

The network administrator discovers packet loss on the headquarters and enterprise branch networks, and wants to locate the link where packets are lost.

Configure direct link packet loss measurement on all links, including the link between interface B1 of switch S1 and interface C1 of switch S2.

Configuring iPCA to Implement Packet Loss Measurement on a Direct Link

The network administrator wants to monitor packet loss on the core switches in real time.

Configure device packet loss measurement on core switch S2 or S5.

Configuring iPCA to Implement Packet Loss Measurement on a Device
Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 138164

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next