No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring LLDP to Identify Huawei Fit AP

(Optional) Configuring LLDP to Identify Huawei Fit AP

Prerequisites

The LLDP function has been enabled globally.

Context

When a switch is connected to Huawei fit APs, the interfaces connected to APs must be added to the AP's management VLAN in untagged mode. If many APs are connected to the switch, the configuration is complex. To facilitate operation, run the lldp auto-vlan vlan-id sensor ap command to enable the switch to automatically add the interfaces receiving LLDP packets from APs to the AP's management VLAN in untagged mode.

In Figure 3-9, a switch is connected to many Huawei fit APs. To ensure that the APs can go online, add all interfaces connected to the APs to the AP's management VLAN.

Figure 3-9  A switch is connected to Huawei fit APs

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run lldp auto-vlan vlan-id sensor ap

    The switch is configured to identify Huawei fit APs using LLDP and the interfaces receiving the LLDP packets from APs to the specified VLAN.

    By default, this function is disabled.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 142356

Downloads: 55

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next