No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Ensuring Data Integrity

Ensuring Data Integrity

Context

During traffic distribution, devices should not modify packets before the packets reach the packet analysis server in order to ensure the accuracy of traffic analysis.

NOTE:

The function of ensuring data integrity applies to both IPv4 and IPv6 packets.

After a device is configured to ensure data integrity, the device can only perform Layer 3 forwarding but cannot perform Layer 2 forwarding. Therefore, it is recommended that you configure traffic distribution on a switch where no other features are configured to avoid the failure of features that use Layer 2 forwarding.

Procedure

  • Configure a VLANIF interface on a device to ignore MAC address check during Layer 3 forwarding.

    Specify a VLANIF interface.

    1. Run the system-view command to enter the system view.
    2. Run the interface vlanif vlan-id command to enter the VLANIF interface view.
    3. Run the ip forward-mode dstmac-independent command to configure the VLANIF interface to ignore MAC address check for IP packets.

    Batch specify VLANIF interfaces.

    1. Run the system-view command to enter the system view.
    2. Run the ip forward-mode dstmac-independent interface vlanif { vlan-id1 [ to vlan-id2 ] } &<1-10> command to configure a batch of VLANIF interfaces to ignore MAC address check for IP packets.

  • Disable the device from replacing the source and destination MAC addresses of IP packets during Layer 3 forwarding.
    1. Run the system-view command to enter the system view.
    2. Run the ip forwarding mac-unvaried command to disable the device from replacing the source and destination MAC addresses of IP packets.
  • Keep the TTL value unchanged.
    1. Run the system-view command to enter the system view.
    2. Run the interface interface-type interface-number command to enter the interface view.
    3. Run the set ttl unvaried command to configure the device to retain the TTL value of IP packets.

      NOTE:

      The function of keeping the TTL value unchanged is available only for inbound interfaces.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 135057

Downloads: 53

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next