No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R011C10 Configuration Guide - Network Management and Monitoring

This document provides the configurations of network management and monitoring features supported by the product, including SNMP, RMON and RMON2, LLDP, Performance Management, iPCA, NQA, Service Diagnosis, Mirroring, Packet Capture, Traffic Distribution, NetStream, sFlow, and TWAMP Light.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring iPCA to Implement Network-Level Hop-by-Hop Packet Loss Measurement

Configuring iPCA to Implement Network-Level Hop-by-Hop Packet Loss Measurement

Context

When you detect that packet loss occurs on the network and want to find out the network node where packet loss occurs, you can configure iPCA hop-by-hop packet loss measurement.

In Figure 5-17, target flows enter the transit network through Switch_1, pass Switch_2, and leave the network through Switch_3. Configure hop-by-hop packet loss measurement on Switch_1, Switch_2, and Switch_3. When packet loss occurs on the transit network, you can collect packet loss statistics by dividing the network into multiple segments and locate the packet loss points.

Switch_1, Switch_2, and Switch_3 function as DCPs to control and manage TLP 100, TLP 200, and TLP 310, collect packet loss statistics, and send the statistics to the MCP. Switch_1 functions as the MCP to collect packet loss statistics from DCP1, DCP2, and DCP3, summarize and calculate the statistical data, and report the statistical results to user terminals or NMS.

NOTE:

There may be iPCA-incapable devices between Switch_1 and Switch_2 and between Switch_2 and Switch_3.

Figure 5-17  Networking of iPCA hop-by-hop packet loss measurement

Pre-configuration Tasks

Before configuring iPCA to implement network-level hop-by-hop packet loss measurement, complete the following tasks:

  • Configure static routes or routing protocols to ensure network connectivity between devices. For details, see S12700 V200R011C10 Configuration Guide - IP Unicast Routing.
  • Configure NTP to implement time synchronization between the devices. For details, see NTP Configuration in the S12700 V200R011C10 Configuration Guide - Device Management.

Configuration Procedure

Configuring the DCP and Configuring the MCP can be configured in any sequence. The parameter settings on MCP and DCPs must be the same.

Translation
Download
Updated: 2019-10-21

Document ID: EDOC1000178113

Views: 138213

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next